Colour Changeable LED Plinth and Floor Light (Waterproof IP67, 12vdc)

Our Litewave ® Stainless Steel LED Plinth & Floor Lights will provide attractive accent lighting in Floors & Skirting, Decking, Kitchen Plinths, and even Bath and Shower surrounds.

5 Year Warranty

• Suitable for use Indoors or Outdoors
• Low power
• Does not get hot or project any heat or UV light
• High Quality
• Branded
• 3 Year Warranty

This product is finished with a 304 Stainless Steel bezel (will not rust) and is waterproof to IP67 (submersible). The light is emitted through an frosted polycarbonate lens which gives a soft light rather than a blinding beam.

Unlike many cheap LED Plinth Lights available elsewhere these have built-in Constant Current Circuitry. This keeps the voltage and current to the LED at an optimum to reduce stress to the LED thus greatly extending it's lifetime.

Used on it's own it can display 7 Colours; White, Blue, Green, Red, Purple, Yellow, and Cyan. Simply connect either the Red, Green or Blue wires to the power supply to get one of those colours, or a combination such as blue and green to get Cyan. For virtually unlimited colours we recommend using a colour controller.

If you connect it to our Flexi (2.1 Million) Colour Driver the colour range will be virtually unlimited with gradual smooth colour sweeps which can be frozen on any colour. We have additional controllers (see below) that allow them to be operated via wired remote (ZAP) or wireless remote (ZEN), these allow the power to be switched off, the lights will resume their last setting / colour when switched on again.

Alternatively you can control them from a Lightbox (Bluetooth), or WLightbox (Wi-Fi). With either of these a Flexidriver is not required. Both ofthese products allow full control of the colour, saturation, brightness, and speed of colour change from a smartphone or tablet using a freely downloadable app.

Connection guide for the Plinth Lights

Although they draw little power, they will provide a reflected glow from walls and ceilings, enough to see around the room.

Each Plinth light is pre-wired with 2 × 1 Meter cables each with opposite waterproof connectors allowing the lights to be daisy chained. This makes installation easy with only the first light in the chain needing to be connected to the Power Supply or the Flexi Driver.

You can have just one light in the installation or a chain of them displaying the same colours at the same time, if additional Flexi Drivers are used different Zones can be created for independent colours. They will work in conjunction with our other LED Mood Lighting Products for a complete lighting network, all controlled via one Remote Control.

A well built product at an affordable price.

We stock a 1 Meter Plug and Play extension cable for areas where you need to extend the cable between the lights (see related items below)

There are a choice of 3 Power Supplies, a Plug-top type for plugging directly into a mains socket or an In-Line type for Wiring to a Light Switch. The 1A PSU can run up to 14 Plinth Lights, and the 2A PSU can run up to 30 of them.